Just push on the output number you want to select. The top buttons will be white to show the numbers of output available and the active output will be blue. To change the active output with the XC8, hold the SHIFT button down (at the bottom of the vertical NKK buttons). ![]() ![]() Note that the number of the input or output is depending on the order in which they show up in the Inputs and Outputs panes. The behaviour of these buttons do not change depending on the active area, they always control the selected outputs and inputs of the Viewers area. Jog/Shuttle: Depending on the active area, it will either control the playback, or allow to select a clip in the browser or playlist.Horizontal NKK Buttons: Set in/out points, mark, play/pause.Display: Shows the selected output and each assigned input.Vertical NKK buttons: Perform different actions such as go to live, select the active area, or the shift key.Top buttons: Select which output is selected in the Viewers area and which input is assigned to it.There are 6 main areas on your XC8 that we’ll refer to in this manual: Also, different buttons may light up (if some buttons don’t show up immediately, don’t hesitate to push again on them). Once the XC8 is setup and configured, you will need to launch M|Replay to see buttons and the display light up. Buttons and controls may have different "roles" depending on which area of M|Replay is active: the sources, viewer, browser or playlist. Operation of the XC8 About the "Active" areas We have an extensive article that explains how to set it up: So you have to tell the XC8 to which server it needs to connect to. Indeed the way this works is that the XC8 is a "client" and M|Replay is the "server". then set the Unisketch Raw Panel IP address to the IP address of the computer where M|Replay is running.You have to do two things using that tool: The XC8 has to be configured using the SKAARHOJ Firmware Updater application. Elgato's Stream Deck has only buttons to create markers, or control the playback, but it is very limited for playback controls, the best usage of this is to create markers as these can be customised and the buttons labeled.Contour Design's SHUTTLEPro has buttons to create markers, set in/out points and a jog shuttle wheel to control the playback speed.It has buttons to create markers, set in/out points, select the angle to be used, a jog shuttle wheel and a T-bar to control the playback speed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |